Increase the durability and security of your cards by adding one or two Nisca PR5302 heat laminators for PR53XX printers.
- Attach up to two laminators per printer
One or two Nisca PR5302 laminators can be attached to a Nisca PR5310, PR5350, or PR5360LE card printer. Use a laminator to apply lamination to one or two sides of your cards. Use two laminators to greatly increase your print speed or to apply different laminate material on each side of your cards.
- Choose your lamination
Choose from either hardcoat lamination or softcoat (also called thinfilm) lamination. It offers a durable patch to your cards to protect against color fading and scratching. Available in a range of clear and standard or custom holographic options, hardcoat lamination is available in 0.5 and 1.0 mil thickness.
Softcoat (aka, thinfilm) lamination applies edge-to-edge laminate to your cards by adhering to the ribbon's overlay panel. It protects against color bleeding and fading. While it applies more material per roll versus the hardcoat patch material, it is less durable. (Choose hardcoat or softcoat lamination for your Nisca laminator within the Options tab.)
Both Nisca PR5302 laminators have support for either 110 or 120 volt power. (These power requirements must be specified at time of purchase.)
- Install with ease
You can easily add a Nisca PR5302 laminator to your Nisca printer at any time with no additional tools.
- Achieve high speeds
The PR5302 is a high speed laminator for standard CR80 cards. Its high speed communication port interfaces with the card printer and allows the printer's firmware and driver to configure your laminator for a variety of laminate materials. It's also designed to warm-up and cool-down quickly so that you can print and laminate in less than 2 minutes.
- Configure your settings
To optimally locate the laminate on your card, the Nisca PR5302 features sensitive position adjustment settings. Easily adjust the temperature and speed settings to the correct setting for your specific laminate to ensure a perfect bond. To preserve energy, it has a ''sleep'' mode when not in use.
|Additional Info||Nisca PR5302 Laminator|
|Printer Compatibility||PR5300, PR5310, PR5350|